Pool/Spa Heat Pump Installation & Operation Manual Models BR80 XW BR115 XW BR135 XW BR100 BR110 BR135 BR-401
Page | 8 HEAT PUMP OPERATION / DIGITAL CONTROL OPERATION Control On/Off When the unit is powered up, but in the OFF mode, the display will show “OF
Page | 9 Pool/Spa Modes The control is equipped with two independent thermostats, one for pool temperature and one for spa temperature. This is to al
Page | 10 GENERAL MAINTENANCE CAUTION! Make sure all power is disconnected to the heater prior to washing. Cleaning Your heater requires only min
Page | 11 TROUBLESHOOTING To verify that your heater is heating your pool, place your hand above the unit. Cool air will blow out of the top of the h
Page | 12 SERVICE INFORMATION All service must be handled by an Authorized Service Center. Warranty may be void if a non-authorized service represen
NOTES _______________________________________________________________________________________________________________________________________________
Built Right Pool Heaters, LLC. 8260 Pascal Dr Punta Gorda, Fl 33950-4726
HEAT PUMP LIMITED FACTORY WARRANTY This warranty applies to all models installed within the State of Florida after September 1, 2010 (all versions,
Page | 1 Table of Contents Important Information Log 2 Introduction 3 Installation 4-5 Location Recommendations
Page | 2 Please Read Carefully For your records, please complete the information requested below. Should warranty service be required, the followi
Page | 3 INTRODUCTION Thank you for your purchase of a Built Right pool and spa heat pump, proudly made in Punta Gorda, Florida. To ensure a long wo
Page | 4 INSTALLATION Location Recommendations Make sure the heat pump is not located where large amounts of water may enter the heater. This inclu
Page | 5 Water Piping For your convenience the heater’s inlet and outlet are labeled. 2” PVC Unions are provided with the heater. The piping sequenc
Page | 6 ELECTRICAL HOOK UP The wiring of your heater should be performed by a qualified electrician in accordance with local code requirements. C
Page | 7 Using an External Controller Push the remote wires from the external controller through the rubber plug on the bottom left side of the co
Comments to this Manuals